Xerox DC User Manual download pdf (Page 326)

Page 15 - 8 Xerox Document Centre Reference Guide

Paper

Handling

(cont’d)

Repeated Check Tray

Messages on the User

Interface and the paper is

loaded in the tray

Adjust the edge guides against the stack of

paper in the tray.

If the edge guides were not set against the

paper stock in the tray when Start was

selected, delete the job in the job queue and

begin again.

Paper Curls

Load the paper in the paper trays seam side

of the paper up. Load the paper in the High

Capacity Feeder and Bypass Tray with the

seam side down.

Load non-standard media in the Bypass

Tray.

If the paper curls excessively, flip the paper

over in the applicable paper tray.

The Finisher does not stack

the output correctly

Unload the finisher tray frequently.

Depending on your machine configuration

there may be a pause button on the side of

the finisher.

Do not remove stapled sets while the

finisher is compiling.

The Finisher does not

staple or staple well

The finisher does not staple stacks of more

than 50 sheets of 20 lb. paper.

Use less than 50 sheets of paper if they are

heavier than 20 lb.

Check the User Interface for a fault

message indicating no staples. Replace the

staple cartridge.

Problem Symptom Recommendation

The seam refers to the side of a

ream of paper with a split in the

wrapping. It may also be

referred to as arrow side first.

1 2 ... 321 322 323 324 325 326 327 328 329 330 331 ... 351 352

Comments to this Manuals

No comments