Xerox XE60 User Manual download pdf (Page 19)

Connecting the Parallel Cable (XE80, XE82 only)

1. Connect the IEEE-1284 parallel cable to the parallel port on the back of

the WorkCentre.

2. Connect the IEEE-1284 parallel cable to the parallel port on the back of

the PC.

Turn to the Printer Driver Software Installation section in this User

Guide to set up the WorkCentre XE for printing.

Connecting the Power Cord

As electricity is always dangerous if not used properly, please

take all necessary precautions to prevent electric shocks when

connecting and disconnecting the WorkCentre.

If you use the WorkCentre in a country other than the country

where the WorkCentre was purchased, you will need to make sure

that your local power supply is compatible with your model. If you

plug the WorkCentre into an incompatible power supply,

irreparable damage to the WorkCentre will result.

1. Check that the power switch for the WorkCentre is in the OFF position.

The switch is located on the lower left hand side of the WorkCentre and

labeled “O” for OFF and “I” for ON.

2. Connect the power cord to the power cord socket in the rear left hand

corner of the WorkCentre, and then plug the other end into a properly-

grounded power outlet.

The WorkCentre should only be plugged into a properly-grounded

wall socket. Do not plug the WorkCentre into a power strip.

3. Load paper (refer to Loading Media).

4. Turn on the power switch ON.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 57 58

No comments

Xerox XE60 User Manual Page 19