Xerox PE220 User Manual download pdf (Page 63)

4 Copying

Xerox PE220 4-9

1. Place the ID Card to be copied on the document glass and close the

cover.

2. Press Menu until “Copy Feature” appears on the top line of the display.

3. Press the scroll button ( or ) until “ID Card Copy” displays on the

bottom line.

4. Press Enter to confirm your selection.

5. If necessary, customize the copy settings, including Lighten/Darken and

original type, by using the control panel buttons. See “Selecting Copy

Options” on page 4-5.

6. Press Start to begin copying.

Your machine begins scanning the front side.

7. When “Set Backside” displays on the bottom line, open the document

cover and turn the card over. Close the cover.

8. Press Start again.

NOTE: If you press the Stop/Clear button or if no buttons are pressed for

approximately 30 seconds, the machine cancels the copy job and returns to

Standby mode.

2 Up or 4 Up Copying

This copy feature is available only when you load documents in the ADF.

1. Load the documents to be copied in the ADF.

2. Press Menu until “Copy Feature” appears on the top line of the display.

3. Press the scroll button ( or ) until “2 UP” or “4 UP” displays on the

bottom line.

4. Press Enter to make your selection.

5. If necessary, customize the copy settings, including Lighten/Darken and

original type, by using the control panel buttons. See “Selecting Copy

Options” on page 4-5.

6. Press Start to begin copying.

NOTE: You cannot adjust the copy size using the Reduce/Enlarge button

for making a 2 or 4 Up copy.

Poster Copying

This special copy feature can be applied only when you place a document on

the document glass. If a document is detected in the ADF, the Poster copying

feature does not work.

1 2

3 4

1 2

2-up copying

4-up copying

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 199 200

No comments

Xerox PE220 User Manual Page 63