Security
100 ColorQube 9301/9302/9303 Multifunction Printer
System Administrator Guide
4. If you selected Tunnel Mode, under Enable Security End Point Address, select the address type.
Options are Disabled, IPv4 Address, or IPv6 Address.
5. Under IPsec Security, select ESP, AH, or BOTH.
6. Type the Key Lifetime, and select Seconds, Minutes, or Hours.
7. Under Perfect Forward Secrecy (PFS), select None, Group 2, or Group 14.
Note: PFS is disabled by default. PFS allows faster IPsec setup, but is less secure.
8. Under Hash, select from the following:
− SHA1
− None
9. If you selected ESP or BOTH for the IPsec Security type, select one or more of the following
Encryption types:
Note: If the IPsec Security type is set to AH, the Encryption type options do not appear.
− AES
− 3DES
− Null
10. Click Save to apply the new settings or Undo to retain the previous settings.
Editing or Deleting an Action
To edit or delete an action, select the action from the list, then click Edit or Delete.
Managing Host Groups
Host groups are groupings of computers, servers, or other devices that you want to control using security
policies.
Creating a New Host Group
1. Click Host Groups at the top of the IPsec page.
2. Click Add New Host Group.
3. Type a Name and a Description for the group.
4. Under Address List, select IPv4 or IPv6.
5. Select an Address Type. Options are Specific, All, or Subnet.
6. Type the appropriately formatted IP address.
7. To continue to add addresses to the group, click Add.
8. To delete addresses, next to any address, click Delete.
9. Click Save to apply the new settings or Undo to retain the previous settings.
Editing or Deleting a Host Group
To edit or delete a host group, select the host group from the list, and click Edit or Delete.
Comments to this Manuals