Xerox WorkCentre 5230V ATE User's Guide download pdf (Page 105)

More Fax Options - Fax

105

Off

Disables the feature.

Sets the F Code transmission. [F Code] and [Password] are displayed at the right side

of the screen.

• F Code - You can enter an F Code composed of spaces, numerals (0-9), and

symbols (#, *) up to 20 characters. Enter the code using the numeric keypad on the

control panel.

• Password - You can enter a password composed of spaces, numerals (0-9), and

symbols (#, *) up to 20 characters. Enter the code using the numeric keypad on the

control panel.

More Fax Options - Fax

This section describes the advanced features available for fax transmissions. For

information, refer to the following:

Remote Polling – page 105

Store for Polling – page 106

On-hook (Manual Send/Receive) – page 108

Make sure that the Fax service is enabled.

Press the <All Services> button

on the control panel.

Select [Fax] on the touch

screen.

Select the [More Fax Options]

tab.

Select the required feature.

Remote Polling

This feature allows you to retrieve a document from a remote machine, referred to as

“remote polling”. The remote machine information is entered using the same method

for sending faxes, but the [Remote Polling] option is used to initiate retrieving the fax

from the remote machine. You must know the mailbox number and the passcode (if set

up) of the remote machine to retrieve the document.

NOTE: To poll a document from a remote machine, the remote mailbox feature must

be enabled. For more information, refer to

Remote Mailbox on page 103

NOTE: The DTMF (dual tone multi-frequency) method and F Code (ITU-T

subaddress) method can also be used to poll a document from a remote machine. For

more information, refer to

Special Characters on page 84

F Code on page 104

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 181 182

No comments

Xerox WorkCentre 5230V ATE User's Guide Page 105