Xerox Nuvera 120 User Manual download pdf (Page 8)

Xerox Nuvera™ 100/120 Digital Copier/Printer Customer Expectations Document

- 8 -

Product Space & Power Requirements

Item Xerox Nuvera™ 100/120 Digital

Copier/Printer

Comments

Size – Printer

w/ 1 SFM &

Professional

MFF

131.3” (W) x 30” (D) x 61.6” (H)

3336mm x 736mm x 1565.6mm

Width –

additional

SFM

31.7” ( 805mm)

Optional

Service Space Fixed: 162” (W) x 113” (D)

( 4114.8mm x 2870.0mm)

Moveable: 162” (W) x 92” (D)

( 4114.8mm x 2336.8mm)

- Fixed (stationary) installation: rear of the

system should be at least 30” from the wall.

- Moveable installation: rear of the system

should be at least 10” from the wall and must

be on mobility plates OR hard surface floor

AND 4 modules or less.

Weight 1,753 lb. (795.1 kg)

Additional SFM – 423 lbs. (191.9 kg)

With consumables loaded (except media)

Power and

Agency

Requirements

North America

208 Volts / 30 Amp sole use, 60 Hz

Two phase, 3 wire + PE (L1, L2, N, GND)

• UL & cUL compliant

• Complies with the FEMP (Federal Energy

Management Program) via the machine

circuit breaker (CB); with the CB switched

off, the system consumes less than 1 watt.

• Energy Star (eStar) compliant

• Environmental Choice (Canada)

•

Complies with Section 508 of the ADA

Rehabilitation Act

Power

Requirements

Europe/Japan

200-240 Volts / 25 Amp sole use, 50 Hz

Single phase, 2 wire + PE (L, N, GND)

• Energy Star (eStar) compliant

• Units are compliant with applicable EU

directives and are CE marked

System Configuration and Installation

Installation Preparation Document

This section should be used in conjunction with the Xerox Nuvera™ 100/120 Digital Copier/Printer

Installation Planning Guide (IPG) and the Xerox Nuvera™ 100/120 Digital Copier/Printer Installation

Preparation Document (IPD), which contain detailed specifications for size, weight, electric, and

environmental conditions. Only the most important requirements are stated here.

Customer Responsibilities

The following must be completed before the system can be delivered and will be assessed in the final site

check:

Item Comments

Identify placement of the system

Ensure the printer can be delivered to the site

Supply the appropriate electrical connections Dedicated power required

Install an exhaust duct to vent hot air to the air

system or the outside if required

Heat Vent Kit is available for stationary system

installations only. The kit lowers the system’s output

from approximately 17,500 BTU/hour to 8,500 BTU/hr.

Verify the strength and slope of the floor

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 33 34

Comments to this Manuals

No comments

Xerox Nuvera 120 User Manual Page 8

Comments to this Manuals

Related products and manuals for Printers Xerox Nuvera 120