Xerox Phaser 6022 User Manual download pdf (Page 83)

Maintenance

Xerox

Phaser

6022 Printer 83

User Guide

Cleaning the Exterior

Clean the exterior of the printer once a month.

• Wipe the paper tray, output tray, control panel, and other parts with a damp, soft cloth.

• After cleaning, wipe with a dry, soft cloth.

• For stubborn stains, apply a small amount of mild detergent to the cloth and gently wipe the stain

off.

CAUTION: Do not spray detergent directly on the printer. Liquid detergent could enter the printer

through a gap and cause problems. Never use cleaning agents other than water or mild detergent.

Cleaning the Interior

After clearing paper jams or replacing a toner cartridge, inspect the inside of the printer before closing

the printer covers and doors.

• Remove any remaining pieces of paper or debris. For details, see Clearing Paper Jams on page 105.

• Remove any dust or stains with a dry, clean cloth.

WARNING: Never touch a labeled area on or near the heat roller in the fuser. You can get burned. If

a sheet of paper is wrapped around the heat roller, do not try to remove it immediately. Switch off

the printer immediately and wait 20 minutes for the fuser to cool. Try to remove the jam after the

printer has cooled.

Cleaning the LED Lenses

If prints have voids or light streaks through one or more colors, use the following instructions to clean the

Light Emitting Diode (LED) lenses.

WARNING: If you accidentally get toner on your clothes, lightly dust them off as best as you can. If

some toner remains on your clothes, use cool water, not hot, to rinse off the toner. If toner gets on

your skin, wash it off with cool water and a mild soap. If you get toner in your eyes, wash it out

immediately with cool water and consult a doctor.

1. Turn off the printer.

2. Open the side door.

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 137 138

No comments

Xerox Phaser 6022 User Manual Page 83