Xerox Phaser 3330 User Manual download pdf (Page 32)

Configuring Network Settings

About TCP/IP and IP Addresses

Computers and printers primarily use TCP/IP protocols to communicate over an Ethernet

network. Generally, Macintosh computers use either TCP/IP or the Bonjour protocol to

communicate with a network printer. For Macintosh OS X systems, TCP/IP is preferred.

Unlike TCP/IP, however, Bonjour does not require printers or computers to have IP

addresses.

With TCP/IP protocols, each printer and computer must have a unique IP address. Many

networks and cable and DSL routers have a Dynamic Host Configuration Protocol (DHCP)

server. A DHCP server automatically assigns an IP address to every computer and printer

on the network that is configured to use DHCP.

If you use a cable or DSL router, for information on IP addressing, refer to the

documentation for your router.

Installing the Software

Before you install driver software, verify that the printer is plugged in, turned on,

connected correctly, and has a valid IP address. If you cannot find the IP address, see

Locating the IP Address of the Printer.

If the Software and Documentation disc is not available, download the latest drivers

from www.xerox.com/office/3330drivers.

Operating System Requirements

Windows Vista, Windows 7, Windows 8, Windows Server2008, WindowsServer2008 R2,

and Windows Server 2012.

• Macintosh OS X version 10.9 and later

• UNIX and Linux: Your printer supports connection to various UNIX platforms through

the network interface. For details, see www.xerox.com/office/3330drivers.

Xerox

Phaser

3330 Printer3-6

User Guide

Installation and Setup

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 113 114

No comments

Xerox Phaser 3330 User Manual Page 32