Xerox 2060 User Manual download pdf (Page 74)

Supplies

A-4 System Overview Guide

• Letterhead: Different inks and dry inks are used to produce

preprinted letterhead that may not pass through the printer

intact. It is recommended that you run a sample job through

the printer to determine output quality. The loading

orientation of letterhead paper depends on how the job is

programmed. It is recommended that a sample job always be

run first to determine output quality.

• Tabbed inserts: Can be loaded into tray 3 as non-standard

paper. Tabbed inserts can be run from, but are not

recommended for, the optional tray 4 as non-standard paper.

When loading, the non-tabbed, short edge of the tabbed

insert should be the lead edge to the printer.

• Predrilled paper: Has a varying number of holes for use in

binders or binder rings. Before loading predrilled paper, fan it

to remove loose plugs that could cause paper jams.

– Simplex print jobs: Load the drilled paper into trays 1, 2,

or 3 with the holes positioned toward the rear of the paper

tray.

– Duplex print jobs: Load the drilled paper into trays 1, 2,

or 3 with the holes positioned toward the front of the paper

tray.

• Perforated paper

• Non-standard size paper: Paper (7.2 to 12.6 [LEF] or 7.2 to

19.2 [SEF]) can be loaded into tray 3 and optional tray 4.

Ensure that non-standard size paper is selected on tray 3 and

optional tray 4.

• Oversize paper: Paper (12 x 18” [SEF] or 12.6 x 17.7” /SRA3

[SEF]) can be loaded in trays 1 and 2 after the paper guides

are removed by a Xerox service representative.

Paper care

Once you have purchased your paper, you must be sure it is

stored and conditioned properly, so that it performs optimally in

the printer with a minimum of jams.

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 89 90

No comments

Xerox 2060 User Manual Page 74