Xerox WORKCENTRE PE120I User Manual download pdf (Page 39)

Xerox WorkCentre PE120i System Administration Guide Page 3-5

NetWare

Using NetWare Utilities

Installation Procedure

There are three stages required to install the WorkCentre PE120i on a NetWare network using

NetWare utilities:

¾ Network Communication Setup

This procedure will enable the WorkCentre PE120i to communicate on the

NetWare network.

¾ NetWare Setup

This procedure is used to setup the network using NetWare utilities, for

example NWADMIN.

¾ Te st P ri n t

A print job should be submitted to ensure the WorkCentre PE120i has been

installed and configured correctly.

If running NLSP, ensure that RIP/SAP compatibility is configured on the same segment as the

WorkCentre PE120i.

Network Communication Setup

At the WorkCentre PE120i, perform these steps:

HINT: Xerox CentreWare Internet Services can also be used to configure the

WorkCentre PE120i, refer to the Internet Services chapter for instructions.

¾ Ensure that the Basic TCP/IP settings have been configured (see “Network

Communication Setup” on page 2-5).

¾ Press [Menu] until you see

Network Setup on the top line of

the display.

8. Network Setup

[Reset Network]

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 130 131

No comments

Xerox WORKCENTRE PE120I User Manual Page 39