Xerox DocuColor 5000AP User Manual download pdf (Page 14)

DocuColor 5000AP Getting Started

Get started now!

How to Power On/Off the Digital Press

Use the Power Switch to power ON or power OFF the Digital

Press.

How to Load Paper

You can load a wide variety of coated or uncoated standard paper

sizes and weights into the Paper Trays, ranging from 7.2 x 10.1

inch, Long Edge Feed (LEF) or Short Edge Feed (SEF) to 12.6 x

17.7” (LEF).

Acceptable weight ranges are from 60 to 300 g/m

The weight

range of the paper loaded is shown on the Machine Status screen.

Perform the following steps to load paper:

NOTE: Many suppliers use arrows on the paper ream labels to

indicate the preferred side to image first. Use this side (as

indicated by the arrow) as equivalent to the seam side when

loading the paper.

1. Pull out the tray slowly until it stops.

2. Load the correct size paper into the tray in the correct

feeding orientation.

• Load the paper seam side (the side on which the ream

of paper is sealed) up in all the trays.

• Do not load materials above the MAX line located on

the rear Edge Guide.

ON/OFF

Press the Power Switch to the ON position to power ON

the Digital Press.

A screen message advises of a short wait while the

Fuser warms up and the Digital Press runs a system

check. You can program the Digital Press for a job

during this time and the printing process will start

automatically when the Digital Press is ready.

OFF

Press the Power Switch to the Off position to power off

the Digital Press.

Allow the Digital Press to remain off for a minimum of 10

seconds before switching the power ON again.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

No comments

Xerox DocuColor 5000AP User Manual Page 14